515 Power Supply Fan Not Detected Hp 8000

Hullo all,

I am the systems admin in a lowercase office. We are 60+ users. Around 2 weeks agone I detected that 2 PCs were showing error 515 - Superpowe supply fan not detected. I did several troubleshooting and replace the power provision with another one I knew it was working, and it worked, so motherboard malfunction is discarded. I proceed and so to order the 2 power supplies from HP warranty.

Problem is, since then I stimulate 3 more PCs with the aforementioned wrongdoing and I think there´s more to it than just simple coincidence.

PCs: HP Compaq 8200 Elite SFF

Note: I resilient in a commonwealth where current is precise unstable. Server elbow room is backed sprouted away heavy UPSes but the desktops are not.

Whatever thoughts?


Common Topics in HP Hardware
Which of the following retains the information it's storing when the organisation top executive is reversed off?
  • ROM
  • CPU
  • RAM
  • GPU
88% of IT pros got this right.

9 Replies

Big Green Man
Big Super acid Man This person is a Verified Professional
This person is a verified professional.
Avow your bill to enable IT peers to see that you are a occupational group.
Jul 8, 2022 at 13:13 UTC

Could be dented PSUs, like you suspect. Could also cost a firmware bug. Are every last of the affected PCs on the same BIOS variant? Fancy if there's an upgrade available.

Ross42.
Ross42. This person is a Verified Professional
This person is a verified professional.
Verify your account to enable IT peers to see that you are a professional.
Jul 8, 2022 at 13:20 UTC

My guess would make up the dirty power has wrecked the PSUs.

Caur

This can too befall across Lots if you purchase in bulk. Withal, due to the timing, I am with the others saying that the PSU's are acquiring messed up by your powerfulness situation. +1 for UPS.

Ram (Horizon DataSys)

Brand Representative for Horizon DataSys

Yeah peculiarly when you know that your area  is illustrious for coseismic electrical incumbent, its definitely get UPS even for your desktops.

Specter01101
Specter01101 This person is a Verified Professional
This individual is a verified occupation.
Verify your account to enable IT peers to get wind that you are a professional.
Jul 8, 2022 at 15:48 UTC

I would start with the familiar suspects look-alike FW and updates.  Since your power quality is not adequate to par, a cheap UPS with very little run time mightiness be in lodg for every desktop.  This give the axe get expensive fast but erst these PCs are kayoed of warranty it might be more cost effective.  You might also look into replacing all the desktops with laptops since they have an Actinium adapter that compensates for in straitened circumstances power quality and A battery for when things run short twilight for a spell.

CrashFF
CrashFF This person is a Verified Professional
This person is a verified professional.
Verify your account to enable IT peers to see that you are a professional.
Jul 8, 2022 at 16:11 UTC

Get a control board mount mogul conditioner installed. It'll fix the power fluctuations for the entire building in one hug dru, and cost to a lesser extent in the long run since virtually hardwired units have about a 25 year lifespan.

Priscilla@HP

Brand Representative for HP

Hello Dinko07, give thanks you for your post.  Do you mind pinging me with several product numbers and serial numbers of the computers with defective power supplies as well as those of several functional computers soh we put up determine if they are from the same production whole lot and if there is any recall or advisory for that particular batch.  I am referring to point C below.  You ask, "Any thoughts?"  Please besides see the detailed information provided by our consultant:

#####################

Generally on that point are four executable causes:

A. Overheating.

B. Baron problems ("unfavourable electricity"). Read e.g. attached The Seven Types of Superpowe Problems.

C. Product batch susceptible to item failure. Priscilla is going to elucidate this.

D. Gremlins.


The superfine right smart to proceed would be to send pictures of broken power supplies - unopened, opened but non cleaned, opened and cleaned.

Re A: Overheating
What is your common ambient temperature? How dusty is your surround? Big, little or tiny dust particles? What form of particles? Wood, metal, theme, pee, oil etc.?  What is your usual close air humidity?

Atomic number 75 B: Big businessman Problems

I deficiency first to handle a misconception approximately UPS. The primary function of UPS is to provide backup big businessman for the connected load during electrical reference grid memory loss. To achieve this, UPS itself needs to atomic number 4 protected from power problems, which are usually organized into categories on a lower floor:
1. Transients
2. Interruptions
3. Sag down / Undervoltage
4. Swell / Overvoltage
5. Wave form distortion
6. Voltage fluctuations
7. Frequency variations

A UPS broken aside just about major power job can't naturally fulfill its primary function of providing patronage mightiness. However, I want to emphasize that it is not a primary function by choic for UPS to protect equipment against power problems. That is why the level a UPS can protect against power problems is limited in scope in comparison with ordained devices, e.g., AC power logical argument filters.

AC Power cable Filters
They are planned to handle much wider range and higher intensity of power problems than standard filters used in most UPS'. Furthermore, they are quite a fast in doing their job every bit their response time is rhythmic in nanoseconds. The AC power cable filters are produced in different levels of protection and for different maximum electric automobile currents on single or three phases mains. The tercet-stage AC power line filters offer the highest steady of protection against power problems, e.g. here.

Of course, the level of protection offered past the UPS varies on the type of UPS:
- Offline UPS (low-down trade protection against power problems)
- Online UPS (higher protection against superpowe problems)
- Online UPS with isolation transformer (soaring shelter against power problems)

Cascading

IT is possible to interconnect AC power cable filtrate and UPS into thus called cascading. That is from power mains into the AC line filter and then from filter's output into the UPS stimulation. This will step-up some UPS' and load's protection against power problems. More details can glucinium found e.g. here.

HP UPS

H.P. is producing three lines of UPS':
1. 500 W - 7 kW

2. 12 kW - 19.9 kW

3. 8 kVA - 36 kVA

Flow Battery

A very good alternative to UPS are flow batteries. They offer low-toned maintenance, life span up to 50 years, oblong scalability (1 kWh - 10 MWh), fantabulous connectivity to renewable power sources, etc.

See additional selective information in the next post.

######################

Since this is your first post, a lively wanted to Spiceworks.

Altered Jul 12, 2022 at 14:10 UTC
Priscilla@HP

Marque Representative for HP

@Dinko07, to address directly your trouble, here is a quick, simple and inexpensive resolving from our consultant:

Ferrite Pearl EMI/RFI Filters
However, in front considering to set up AC power line filters and/or UPS' for individual workstations, one of these days for entire floor or integral edifice you could look at cheaper root.
Now, switched-mode power supplies are good in dealing with many power problems. Simply they are generally susceptible to EMI/RFI, which may interfere with power supply's own operating frequency, and which are often the cause of the loser.

Ferrite bead snap connected cleave filters are cheap and very effective room of suppressing EMI/RFI.

  ​
You Crataegus laevigata install ferrite bead EMI/RFI filters on all power cords/cables and entirely data cables obstructed into all devices involved. Split snap along ferrite string of beads are very easily to install on any cable. They are produced with a hole of dissimilar diameters. The filtering consequence is much better if you can relieve oneself at any rate 2 loops direct the bead. You must not stoop data and homocentric cables aggressively.

 #####################

Let us know if take up other questions or require additional data.

This subject has been locked by an administrator and is no more open for commenting.

To extend this discussion, please ask a new enquiry.

515 Power Supply Fan Not Detected Hp 8000

Source: https://community.spiceworks.com/topic/1705425-power-supply-fan-not-detected

Iklan Atas Artikel

Iklan Tengah Artikel 1

Iklan Tengah Artikel 2

Iklan Bawah Artikel